Table of Contents
Advertisement
Operating system
272
To select O A/C: turn and press the control-
X
ler.
Switch cooling with air dehumidification on
X
O or off ª.
i
The current status of the cooling function is
displayed in the climate control bar: A/C ON
– activated, A/C OFF – deactivated.
i
Deactivating the cooling with air dehumidi-
fication function reduces fuel consumption.
Synchronizing the climate control set-
tings
Use O
Sync
(synchronization) to select the cli-
mate control setting for all zones together O or
separately ª.
Call up the climate control menu
X
(
page 271).
Y
Slide 6 the controller repeatedly until the
X
bottom bar is activated.
To select O Sync: turn and press the con-
X
troller.
Switch the synchronization function on O or
X
off ª.
For further information on synchronizing climate
control settings, see (
Navigation mode
Important safety notes
G
WARNING
If you operate information systems and com-
munication equipment integrated in the vehi-
cle while driving, you will be distracted from
traffic conditions. You could also lose control
of the vehicle. There is a risk of an accident.
Only operate the equipment when the traffic
situation permits. If you are not sure that this
is possible, park the vehicle paying attention
to traffic conditions and operate the equip-
ment when the vehicle is stationary.
You must observe the legal requirements for the
country in which you are currently driving when
operating the navigation system.
page 129).
Y
General notes
Among other things, correct functioning of the
navigation system depends on GPS reception. In
certain situations, GPS reception may be
impaired, there may be interference or there
may be no reception at all, e.g. in tunnels or
parking garages.
Audio 20 is equipped with Garmin
(see the manufacturer's operating instructions).
®
The Garmin
MAP PILOT operating instructions
are stored on the SD card as a PDF file. The SD
card box contains a quick guide.
The following descriptions apply to navigation
with COMAND. Further information can be
found in the Digital Operator's Manual.
Selecting a route type and route options
Multimedia system:
Select NaviQNavigation.
X
Select
OptionsQRoute
X
i
If route guidance is active, first slide 6 the
controller and show the menu.
Select a route type.
X
Notes for route types:
Eco Route
R
Calculates an economic route.
Dynamic Traffic Route
R
the USA)
Traffic reports on the route for the route guid-
ance are taken into account.
Calculate Alternative Routes
R
Different routes are being calculated. Instead
of Start, select the
To avoid/use route options: select
X
Options.
Select a route option.
X
Notes for route options:
Use Toll Roads
R
The route calculation includes roads which
require you to pay a usage fee (toll).
Use Carpool Lanes
R
USA)
Prerequisite: your vehicle meets the access
conditions for carpool lanes.
Carpool lanes will be included if the carpool
lanes option is activated.
®
MAP PILOT
Settings.
(only available in
Continue
menu item.
Avoid
(only available in the
Advertisement
Table of Contents
