Table of Contents
Advertisement
1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
To install the cage, first loosen the thumb
screws. Raise the shade to the light
fixture. Tighten all thumbscrews securely.
Repeat x3
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs
fan without the light kit?"
Ceiling Bracket
Downrod
2 of 6
Light Kit Screw
bag
5
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Installing the Bulbs and Glass
Note:
and click "How do I install my
Fan style may vary.
Hanging Fan
Wiring
Assembling the Light
2
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
6
Install a bulb into each of the
sockets. When necessary, replace
with bulbs of same wattage.
Canopy
3
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
Install the three switch housing screws
found in the
hardware bag.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Repeat x3
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1886
1 of 6
Light Kit Screw
bag
3 of 6
Light Kit Screw
bag
ON
8
Glass/Bulbs
Advertisement
Table of Contents
