Restoring The Software - HP dx2708 Troubleshooting Manual

Diagnostic Front Panel LEDs and Audible Codes (Continued)
Activity
System gives an
error message
stating that "Error
912 - computer
cover or side panel
has been removed.
Make sure that any
system access was
authorized and
press F1 to
continue".

Restoring the Software

✎
Troubleshooting Guide
Beeps Possible Cause
Continu- The chassis side
ous cover is open or
beep for would have been
5 removed after
seconds previous power
on.
The Windows operating system and software can be restored to the
original state that they were when you purchased the computer by
using the Restore Plus! CD. See the documentation included with the
Restore Plus! CD for complete instructions on using this feature.
In the event that you lose power during the initial operating system
installation process, use the Restore Plus! CD to install the operating
system.
www.hp.com
Recommended Action
1. Make sure that the Chassis side
cover is closed if not fix it as
directed in the assembling guide.
2. Ensure that any system access was
authorized, check all the hardware
ensuring that no hardware has
been changed or removed. Then
enter the BIOS setup by pressing
F10 then select Hardware Monitor
setup and enable the Reset Case
Open Status.
3. Refer to the F10 Utility Guide for
its functionality and any further
issues.
4. For maximum security, be sure to
establish a setup password. The
setup password prevents
unauthorized access to the
Computer Setup utility.
Troubleshooting
2–14