Solving General Problems - HP dx2708 Troubleshooting Manual

Solving General Problems

Problem
Computer will not
turn on.
Computer appears
locked up and will not
turn off when the power
button is pressed.
* Applicable for non China version.
Troubleshooting Guide
You may be able to easily resolve the minor problems described in
this section. If a problem persists and you are unable to resolve it
yourself or if you feel uncomfortable about performing the operation,
contact your HP authorized reseller or service provider.
Cause
Cables to the external
power source are
unplugged.
Voltage selector switch* on
the rear of the computer
chassis is not switched to
the correct voltage (115V
or 230V).
A defective PCI card has
been installed.
Drive data or power supply
cables may not be
properly connected.
The unit temperature was
exceeded. The fan may be
blocked.
Software control of the
power switch is not
functional.
www.hp.com
Solution
Ensure that cables connecting the
computer to the external power source
are plugged in properly and the wall
outlet is active.
Select the proper AC voltage using the
slide switch.
Remove any expansion board that
was just installed.
Reseat drive data and power supply
cables.
1. Unit is in an exceedingly hot
environment. Let it cool down.
2. Ensure that computer air vents are
not blocked and the internal fan is
running.
3. Contact an HP authorized reseller
or service provider.
1. Press and hold the power button
for at least four seconds until the
computer turns off.
2. Disconnect the power cord from
the electrical outlet.
Troubleshooting
2–5