Troubleshooting - Husqvarna 520iLX Operator's Manual

3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
To do a check of the trimmer line
Only use the recommended trimmer line. See the
illustration on the last pages of the manual.
1. Put the cord into the hole on the cover of the product
to make sure it follows the recommendation.
To replace the trimmer head
Note: To increase the life of the cord it can be soaked in
water for a couple of days before it is assembled. This
will make the cord tougher.
1. Press the snap-in clips on the trimmer head and
remove the trimmer head and trimmer line.
Keypad
LED display
Green activate LED flashing
756 - 003 - 24.06.2020

Troubleshooting

Possible faults
Low battery voltage.
2. Pull out the line chute assembly.
3. Remove the nut that holds the trimmer head and the
drive disc.
4. Replace the trimmer head.
5. Install the nut.
6. Install the line chute assembly.
7. Install the trimmer head.
Possible action
Charge the battery.
15