Rear Window Wiper; Washer; Compass - Chevrolet Suburban 2014 Owner's Manual

(Adjustable Interval Wipes):
Turn the band up for more frequent
wipes or down for less frequent
wipes.
(Low Speed): Slow wipes.
1
(High Speed): Fast wipes.
Clear ice and snow from the wiper
blades before using them. If frozen
to the windshield, carefully loosen or
thaw them. Damaged wiper blades
should be replaced. See Wiper
Blade Replacement on page 10-28.
Heavy snow or ice can overload the
wiper motor. A circuit breaker will
stop the motor until it cools down.
Windshield Washer
{
Warning
In freezing weather, do not use
the washer until the windshield is
warmed. Otherwise the washer
fluid can form ice on the
windshield, blocking your vision.
L
(Washer Fluid): Push this
paddle to spray washer fluid on the
windshield. The wipers clear the
window and then either stop or
return to the preset speed.

Rear Window Wiper/

Washer

The rear wiper control is on the turn
signal lever.
To turn the rear wiper on, slide the
lever to a wiper position.
(Off): Turns the wiper off.
(Rear Wiper Delay): Turns on
the rear wiper with a longer delay
between wipes.
Z
(Rear Wiper): Turns on the rear
wiper with a short delay between
wipes.
=
(Rear Wiper Wash): Press this
button on the end of the lever to
spray washer fluid on the rear
window. The wipers will clear the
rear window and either stop or
Instruments and Controls
return to your preset speed. For
more washer cycles, press and hold
the button.
The rear window wiper/washer will
not operate if the liftgate or liftglass
is open or ajar. If the liftgate or
liftglass is opened while the rear
wiper is on, the wiper returns to the
parked position and stops.

Compass

The vehicle may have a compass in
the Driver Information Center (DIC).
Compass Zone
The zone is set to zone eight upon
leaving the factory. Your dealer will
set the correct zone for your
location.
Under certain circumstances, such
as during a long-distance,
cross-country trip or moving to a
new state or province, it will be
necessary to compensate for
compass variance by resetting the
zone through the DIC if the zone is
not set correctly.
5-5