Original Accessories / Additional Equipment; Initial Operation; Fitting / Changing The Saw Blade - Parkside 90882 Translation Of Original Operation Manual

d) Support large panels to minimise the risk of
GB
blade pinching and kickback. Large panels
IE
tend to sag under their own weight. Supports
CY
must be placed under the panel on both sides,
near the line of cut and near the edge of the
panel.
e) Do not use dull or damaged blades.
Unsharpened or improperly set blades produce
narrow kerf causing excessive friction, blade
binding and kickback.
f) Blade depth and bevel adjusting locking
levers must be tight and secure before making
cut. If blade adjustment shifts while cutting, it
may cause binding and kickback.
g) Use extra caution when sawing into existing
walls or other blind areas. The protruding blade
may cut objects that can cause kickback.
Lower guard function
a) Check lower guard for proper closing
before each use. Do not operate the saw if
lower guard does not move freely and close
instantly. Never clamp or tie the lower guard
into the open position. If saw is accidentally
dropped, lower guard may be bent. Raise the
lower guard with the retracting handle and
make sure it moves freely and does not touch
the blade or any other part, in all angles and
depths of cut.
b) Check the operation of the lower guard
spring. If the guard and the spring are not
operating properly, they must be serviced be-
fore use. Lower guard may operate sluggishly
due to damaged parts, gummy deposits, or a
build-up of debris.
c) Lower guard may be retracted manually
only for special cuts such as "plunge cuts"
and "compound cuts". Raise lower guard by
retracting handle and as soon as blade enters
the material, the lower guard must be released.
For all other sawing, the lower guard should
operate automatically.
6
d) Always observe that the lower guard is
covering the blade before placing saw down
on bench or fl oor. An unprotected, coasting
blade will cause the saw to walk backwards,
cutting whatever is in its path. Be aware of the
time it takes for the blade to stop after switch is
released.
Supplementary notes
■ Do not use any grinding discs.
■ Use only saw blade with diameters correspond-
ing to the label on the saw.
■ When sawing wood or other materials which
may create dusts that are hazardous to health,
always connect a suitable, certifi ed vacuum
extractor device.
■ Wear a dust mask when sawing wood.
■ Use only the recommended saw blades.
■ Always wear ear protectors.
■ Do not allow the teeth of the saw blade to overheat.
■ When sawing plastic, avoid melting the plastic.
Original accessories / additional
equipment
■ Only use accessories and additional equipment
that are specifi ed in the operating instructions
and are compatible with the device.

Initial Operation

Fitting / changing the saw blade

Always pull out the plug from the mains before
changing the saw blade
1. Set the cutting depth (using locking screw for
cutting depth scale
position, 0 mm.
2. Swing the lower blade guard
the release lever
3. Press the spindle lock button
and use the Allen key
screw/washer . Now remove the clamping
screw/washer and the clamping fl ange
(see also Fig. A).
!
) to the minimum
back using
and put the device down.
(until it engages)
to release the clamping
PHKSU 710 A1