Table of Contents
Advertisement
7. After the engine starts, move the choke to off (Fig.
15). If the engine stalls or hesitates, move the choke
back to on for a few seconds. Then move the throttle
lever to desired setting. Repeat this as required.
2
1
m–4201
Figure 14
1. PTO-On
2. PTO-Off
1
2
m–2720
Figure 16
1. Throttle–Fast
2. Throttle–Slow
Stopping the Engine
1. Push the PTO to off (Fig. 16).
1. Move the throttle lever midway between the slow and
fast positions (Fig. 16).
2. Let the engine idle for 60 seconds (Fig. 17).
3. Turn the ignition key to off (Fig. 17).
4. Pull wire off spark plug(s) to prevent possibility of
someone accidentally starting the machine before
transporting or storing machine.
5. Close fuel shut off valve, on front panel before
transporting or storing machine.
Important
before transporting or storing machine, as fuel leakage
may occur. Set parking brake before transporting.
Operating the Power Take Off
(PTO)
The power take off (PTO) switch engages and disengages
power to the electric clutch.
2
Engaging the PTO
1
1. While seated in the seat, release pressure on the
m–2719
2. Place throttle to the fast position.
Figure 15
1. Choke–On
3. Pull out on the power take off (PTO) switch to engage
2. Choke–Off
1
2
3
M–4268
1. PTO—Off
Figure 17
1. Off
2. Run
Disengaging the PTO
3. Start
1. To disengage push the PTO switch to the off position
The Safety Interlock System
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
21
Make sure fuel shut off valve is closed
traction control levers and place in neutral.
(Fig. 18).
1
Figure 18
(Fig. 18).
Caution
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
2
m–4201
2. PTO—On
Advertisement
Table of Contents
