Slab Mount - Carrier PHR5 Installation Instructions Manual

15+ seer2 2-stage packaged heat pump system with r-410a refrigerant single and three phase 2-5 nominal tons (sizes 24-60)

Hide thumbs Also See for PHR5:

Table of Contents

PHR5: Installation Instructions

CAUTION

UNIT/STRUCTURAL DAMAGE HAZARD

Failure to follow this caution may result in property damage.

Ensure there is sufficient clearance for saw blade when cutting the outer

horizontal flange of the roof curb so there is no damage to the roof or

flashing.

Slab Mount

Place the unit on a solid, level pad that is at least 2 in. (51 mm) above

grade. The pad should extend approximately 2 in. (51 mm) beyond the

casing on all 4 sides of the unit (See

pad except when required by local codes.

Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.

Fig.

7). Do not secure the unit to the

Table of Contents