Status; Scale Gloss - Konica Minolta MULTI GLOSS 268Plus Instruction Manual

Calibrate

8.2.3 Status

8.2.4 Scale Gloss

26
After you have entered the new value, a warning
message appears again in the display. You can
again abort the process with operate.
If you confirm the new value by pressing the scroll
wheel, the value will be accepted.
After you have changed all necessary values, you
should recalibrate the measurement device as
usual.
This menu item provides you with information on the
calibration status of the unit.
In particular, you can check here whether the saved
calibration values match those of the holder. The
display also indicates if an error message was
generated as a result of the last autodiagnosis or
calibration. If this has happened, further information
is available under Section Errors and warning
messages.
You can use the Scale menu option to switch back
and forth between Gloss Units and Reflectance (see
the Section on Practical measuring suggestions).
Move the mark to the desired entry and press mode.
A check mark identifies the Scale that is selected.
After you switch the Scale, the unit must not be
recalibrated.