Power Trim And Tilt Switch On Remote Control Or Tiller Handle - Yamaha F40D Owner's Manual

Basic components
set according to operator preference. An ad-
juster lever is located on the bottom of the
tiller handle bracket.
To increase resistance, turn the lever to the
port side "A".
To decrease resistance, turn the lever to the
starboard side "B".
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
B
A
If the resistance does not increase even
when the lever is turned to the port side "A",
make sure that the nut is tightened to the
specified torque.
1. Nut
18
Nut tightening torque:
3.7 Nm (2.7 ft-lb) (0.4 kgf-m)
NOTE:
Steering movement is blocked when the
G
adjuster lever is set to the "A" position.
Check the tiller handle for smooth move-
G
ment when the lever is turned to the star-
board side "B".
Do not apply lubricants such as grease to
G
the friction areas of the steering friction ad-
juster.
EMU26142
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch "
motor down and trims it down. When the
switch is released, the outboard motor will
ZMU02810
stop in its current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 46 and 49.
" (up) trims the
" (down) tilts the outboard