Cleaning The Side Burner; Cleaning Side Burner Tube; Side Burner Maintenance - Weber SPIRIT E-330 Owner's Manual

Hide thumbs Also See for SPIRIT E-330:

Manual (29 pages)

Table of Contents

Available languages

CLEANING SIDE BURNER TUBE

Remove Side Burner Valve

You will need: A Phillips screwdriver.

A) Remove the two screws that secure the side burner

valve plate to the side burner table (1).

B) Release the side burner valve from burner tube by

gently pulling the assembly forward (2). Use care not

to kink the corrugated gas line (3).

Clean the Burner Tube

You will need: A flashlight, a wire (a straightened-out coat

hanger), a suitable stainless steel bristle brush.

A) Look inside the burner tube with a flashlight (4).

B) Clean any debris or blockage from the inside of the

tube with the wire (5).

Reinstall Side Burner Valve

You will need: A Phillips screwdriver.

A) Align side burner valve with side burner tube opening.

m CAUTION: The side burner tube opening

(6) must be positioned properly over the

side burner valve orifice (7).

B) Secure the side burner valve plate to the side burner

table using two screws.

SIDE BURNER MAINTENANCE

m WARNING: All gas controls and supply

valves should be in the off ( ) position.

•

Make sure black igniter wire and white ground

wire are attached to the igniter module inside the

base cabinet. Refer to the "IGNITER MODULE WIRE

CHART."

•

Check that the wires are not kinked.

•

Make sure the electronic igniter button is working by

listening for clicking and looking for sparks at burner.

•

The sparks should be a white/blue color, not yellow.

WWW.WEBER.COM