4. Install the following components:
a)
System board shield
b)
Back cover
c)
Stand
5. Follow the procedure in
Memory module
Removing the memory module
1. Follow the procedure in
2. Remove the following components:
a)
Stand
b)
Back cover
3. To locate the memory module on the system board, pry open the DIMM door on the system board shield [1].
4. Pry the retention clips at each end of the memory module slot until the memory module pops up [2].
5. Lift the memory module from the memory module slot [3].
NOTE:
Depending on the configuration ordered, your system may have up to two memory modules installed on the
system board.
After working inside your
computer.
Before working inside your
computer.
Removing and Installing components
29