Ariens 911396 Owner's/Operator's Manual page 16

5. Pull rope with rapid continuous full arm
stroke to start engine. Allow rope to
rewind slowly.
IMPORTANT: DO NOT let starter handle
snap against bracket.
6. Repeat steps 4 and 5 until engine starts.
(If engine does not start, see
TROUBLESHOOTING on page 25.)
Model 911102
1. Check each item under Before Each
Use in the MAINTENANCE SCHEDULE
on page 17.
2. Open the fuel shut-off valve.
NOTE: It is unnecessary to choke a warm
engine.
3. Move the choke lever to the choke
position.
4. With engine/blade control held against
the handlebar, grasp starter handle and
pull rope slowly until it pulls harder. This
is the compression stroke. Let rope
rewind slowly.
5. Pull rope with rapid continuous full arm
stroke to start engine. Allow rope to
rewind slowly.
IMPORTANT: DO NOT let starter handle
snap against bracket.
6. Repeat steps 4 and 5 until engine starts.
If engine does not start, release the
engine/blade control and perform steps
2 through 5. See engine manual for
detailed instructions.
7. After engine starts, put throttle control in
the Fast position.
Shut Off
1. Release wheel drive control and allow
unit to stop completely (self-propelled
models).
2. Release engine/blade control.
3. Set throttle control to "Stop." (911102)
Mowing Tips
Cut grass when it is dry.
Keep mower blades sharp.
Do not set cutting height too low. For tall
grass, mow twice.
Do not mow too fast.
Mow with engine at full throttle. Discharge
clippings into areas already cut.
Vary cutting pattern with each mowing.
NOTE: To prevent dirt and grass from
collecting on mower pan, avoid operating
over bare ground with only patches of grass.
Mulching Tips
For best mulching performance, cut no more
than 1 inch (2.54 cm) of grass per cutting.
GB - 16