Sewing Various Fabrics; Sewing Thick Fabrics - Brother 888-L01 Operation Manual

Sewing Various Fabrics

Sewing Various Fabrics

Sewing thick fabrics

■ If the fabric does not fit under the presser foot
The presser foot lever can be raised to two different
positions. If the fabric does not fit under the presser foot,
for example, when sewing together thick fabrics, raise the
presser foot lever to its highest position so that the fabric
can be placed under the presser foot.
■ If the fabric does not feed
When sewing thick fabric such as denim or quilting, the
fabric may not feed at the start of sewing if the presser foot
is not level, as shown below. In this case, use the presser
foot locking pin (black button on the left side) of zigzag
foot "J" so that the presser foot remains level while sewing,
allowing the fabric to be fed smoothly.
If the presser foot misalignment is too large, place thick
paper or fabric (with the same thickness as the fabric being
sewn) under the heel of the presser foot to be able to start
sewing smoothly.
a
b
1 Sewing direction
2 Misalignment
3 Fabric being sewn
4 Fabric or thick paper
Raise the presser foot lever.
a
b Align the beginning of stitching, and then position the
fabric.
S-4
c
d
d c
While holding zigzag foot "J" level, push in and hold
the presser foot locking pin (black button on the left
side), and lower the presser foot lever.
1
1 Presser foot locking pin (black button)
Release the presser foot locking pin (black button).
→ The presser foot remains level, allowing the fabric to
be fed.
→ After the seam is sewn, the presser foot will return to
its original angle.
Memo
• You may find adjusting the "Presser Foot
Pressure" in the settings screen helpful on some
thick fabrics.
CAUTION
• If fabric more than 6 mm (15/64 inch) thick is
sewn or if the fabric is pushed with too much
force, the needle may bend or break.