Electro-Voice EVA-2082S Installation Manual page 13

Expandable vertical array
Hide thumbs Also See for EVA-2082S:
Table of Contents

Advertisement

EVA Expandable Vertical Array
EVA-2082S/920 full-range module
EVA-2082S/920 is a two-way, LF/HF line-array module with a 90° horizontal x 20° vertical
coverage pattern (for short throws) and passive crossover/HF-shading/EQ network. The
enclosure is trapezoidal in the vertical plane with a 20° total included angle. The two line-array
elements contained in the module are vertically splayed by 10°.
EVA-2082S/126 full-range module
EVA-2082S/126 is a two-way, LF/HF line-array module with a 120° horizontal x 6° vertical
coverage pattern (for long throws) and passive crossover/HF-shading/EQ network. The
enclosure is trapezoidal in the vertical plane with a 6° total included angle. The two line-array
elements contained in the module are vertically splayed by 3°.
EVA-2082S/1220 full-range module
EVA-2082S/1220 is a two-way, LF/HF line-array module with a 120° horizontal x 20° vertical
coverage pattern (for short throws) and passive crossover/HF-shading/EQ network. The
enclosure is trapezoidal in the vertical plane with a 20° total included angle. The two line-array
elements contained in the module are vertically splayed by 10°.
EVA-AM attenuation module
The EVA-AM attenuation module mounts on the inside of an EVA-2082S input panel, and
attenuates the entire module by 3, 6 or 9 dB. The nominal impedance of an EVA-2082S module
is 16 ohms. Up to six paralleled EVA-2082S modules can be driven from a single amplifier
channel capable of driving a 2.7-ohm nominal impedance (16 ohms ÷ 6 modules = 2.7 ohms).
If at least two of the modules have the optional EVA-AM attenuation modules installed, a single
amplifier channel capable of driving a 2.3-ohm nominal impedance can drive up to eight
paralleled EVA-2082S modules.
EVA-1151D single subwoofer module (discontinued)
EVA-1151D is a compact single 15-inch subwoofer module capable of being flown either above
or behind an EVA full-range array. EVA-1151D is a rectangular unit with special tie plates that
allow for assembly with either 0° or 5° of splay between modules. It may also be used in a
stand-alone subwoofer array or ground-stacked.
EVA-2151D dual subwoofer module
EVA-2151D is a large rectangular dual 15-inch subwoofer module designed for use only at the
top of an EVA full-range array. It may also be used in a stand-alone subwoofer array or ground-
stacked.
Both subwoofers use the DVX3159A 15-inch (381 mm) woofer designed specifically for
subwoofer duty, providing reliable low-frequency performance at high SPL levels with low
distortion and solid impact.
Notice!
i
Subwoofer modules do not have internal passive crossovers and require an active crossover
and dedicated amplifier channel(s) for proper operation.
The standard EVA indoor versions are finished in tough EVCoat™. All EVA modules (except
EVA-2151D ) are available in two levels of weather resistance:
Electro-Voice
Fiberglass (FG) versions like EVA-2082S/906-FGB are designed for full weather exposure.
They feature a fiberglass-finished enclosure, stainless-steel three-layer hydrophobic grille
and the CDG dual-gland-nut input-panel cover.
Installation manual
Introduction | en
13
2023-01 | 04 | F01U196199

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eva-1151dEva-2151d

Table of Contents