Mercedes-Benz SLC 2018 Operator's Manual page 234

Features
232
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding traf-
fic.
In order to calibrate the compass correctly, do
the following:
calibrate the compass in the open and not in
R
the vicinity of steel structures or high-voltage
transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear win-
dow defroster.
close all doors and the trunk lid.
R
Switch on the ignition.
X
Push a round pen into opening =
X
( page 231) for approximately six seconds,
Y
until symbol C
( page 231).
Y
Drive your vehicle in a full circle at approx-
X
imately 3 mph (5 km/h) to 6 mph (10 km/h).
When the calibration has successfully been
completed, the current direction is shown in
compass display ; (
Floormats
G
WARNING
Objects in the driver's footwell may restrict
the clearance around the pedals or block a
depressed pedal. This jeopardizes the oper-
ating and road safety of the vehicle. There is a
risk of an accident.
Stow all objects securely in the vehicle so that
they do not get into the driver's footwell.
When using floormats or carpets, make sure
that they are properly secured so that they do
not slip or obstruct the pedals. Do not place
several floormats or carpets on top of one
another.
is shown in compass display ;
page 231).
Y
Slide the seat back.
X
To install: place the floormat in the footwell.
X
Press studs : onto retainers ;.
X
To remove: pull the floormat off retainers ;.
X
Remove the floormat.
X