Windshield Wipers - Mercedes-Benz SLC 2018 Operator's Manual

Turn housing cover : counter-clockwise and
X
pull it out.
At the bulb holder, push the bulb upwards,
X
disconnect it and pull it out of bulb holder ;.
Insert the new bulb into bulb holder ; at the
X
top, push it down and secure it in place.
Attach housing cover : and turn it clockwise
X
until it engages.
Side marker lamps (halogen head-
lamps)
Due to their location, have the bulbs in the side
marker lamp changed at a qualified specialist
workshop.

Windshield wipers

Switching the windshield wipers
on/off
!
Do not operate the windshield wipers when
the windshield is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windshield can scratch the glass
if wiping takes place when the windshield is
dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always use
washer fluid when operating the windshield
wipers.
!
If the windshield wipers leave smears on the
windshield after the vehicle has been washed
in an automatic car wash, wax or other resi-
dues may be the reason for this. Clean the
windshield using washer fluid after washing
the vehicle in an automatic car wash.
!
Intermittent wiping with rain sensor: due to
optical influences and the windshield becom-
ing dirty in dry weather conditions, the wind-
shield wipers may be activated inadvertently.
This could then damage the windshield wiper
blades or scratch the windshield.
For this reason, you should always switch off
the windshield wipers in dry weather.
Windshield wipers
Combination switch
$ Windshield wiper off
1
Ä Intermittent wipe, low (rain sensor set
2
to low sensitivity)
Å Intermittent wipe, high (rain sensor
3
set to high sensitivity)
° Continuous wipe, slow
4
¯ Continuous wipe, fast
5
í Single wipe/î Wipes the wind-
B
shield using washer fluid
If the wiper blades are worn, the windshield will
no longer be wiped properly. This could prevent
you from observing the traffic conditions.
Replacing the wiper blades
Important safety notes
G
WARNING
If the windshield wipers begin to move while
you are changing the wiper blades, you could
be trapped by the wiper arm. There is a risk of
injury.
Always switch off the windshield wipers and
ignition before changing the wiper blades.
!
To avoid damaging the wiper blades, make
sure that you touch only the wiper arm of the
wiper.
!
Never open the hood if a windshield wiper
arm has been folded away from the wind-
shield.
Never fold a windshield wiper arm without a
wiper blade back onto the windshield.
Hold the windshield wiper arm firmly when
you change the wiper blade. If you release the
windshield wiper arm without a wiper blade
101
Z