12
SERVICE WORK ON THE CHASSIS
–
Tighten screws
Guideline
Screw, bottom triple clamp
V00466-10
–
Tighten screw
Guideline
Screw, top steering head
E00387-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
E00388-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
V00466-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
K00546-11
Finishing work
–
Mount the handlebar cushion.
–
Install the front fender. (
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables, and brake and clutch lines can move
freely and are routed correctly.
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
.
.
.
M8
.
M8
p. 62)
(
p. 88)
p. 99)
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
17 Nm
Loctite
(12.5 lbf ft)
M8
17 Nm
(12.5 lbf ft)
.
.
25 Nm
Loctite
(18.4 lbf ft)
p. 97)
p. 60)
p. 52)
59
®
243™
®
243™
.