12
SERVICE WORK ON THE CHASSIS
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Secure wiring harness and clutch line with cable holder.
–
Position the voltage regulator, and mount and tighten screws
Guideline
Remaining screws, chassis
K00548-11
–
Position the fork legs.
Bleeder screws
Info
The rebound damping is located in right fork leg REB (red adjusting screw).
The compression damping is located in left fork leg COMP (white adjusting
screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
H01672-10
–
Tighten screw
Guideline
Screw, top steering head
V00465-11
–
Tighten screw
Guideline
Screw, top steering stem
V00465-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
V00464-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
K00546-11
but do not tighten yet.
are positioned toward the front.
.
.
.
M8
.
M6
10 Nm (7.4 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M8
20 Nm
(14.8 lbf ft)
.
.
25 Nm
Loctite
(18.4 lbf ft)
57
®
243™
.