Installing A 2.5-Inch Hard Drive - HP Z1 Entry Tower G5 Maintenance And Service Manual

Installing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Install four black-and-blue M3 mounting screws (two on each side of the drive).
NOTE:
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
4. Align the front mounting screws on the drive with the J-slots on the sides of the drive bay. Press the
front of the drive into the drive bay, and then slide the drive forward (1). Then press the rear of the drive
down into the drive bay (2) so that the drive is secured in place.
(Access panel on page
M3 metric mounting screws can be purchased from HP.
(Preparation for disassembly on page
18)
17)
Drives 41