Table of Contents
Advertisement
®
MAGNUM PRO
175L & 250L
INSTALLATION
Read this entire installation section before you
start installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch electrically live parts such
as output terminals or internal wiring.
•
Insulate yourself from the work and
ground.
•
Always wear dry insulating gloves.
Only qualified personnel should install, use or
service this equipment.
IDENTIFY AND LOCATE COMPONENTS - 175L
The Magnum
current to the weld. The components of the gun are identified
below.
1. Nozzle
2. Contact tip - Provides electrical contact to the wire.
3. Gas Diffuser
4. Trigger
5. Gun Tube
6. Collar
7. Gun Handle
8. Brass Feeder Connector
9. Feeder End Connector
10. Set Screw
11. Cable
12. Gun Liner - Wire travels through the liner from the wire drive.
The KP35-40-15 liner comes installed in the gun and will run
.025"-.035" wire.
FIGURE 1 - MAGNUM PRO 175L
A-2
®
PRO 175L welding gun delivers wire and welding
INSTALLATION
Advertisement
Table of Contents
