Electrolux Westinghouse WDU903 User Manual page 17

3. Adjust the rear foot. Turn the screw in the
middle of the front kick-plate to the left or
to the right.
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. Loosen or tighten
the adjustable feet until the appliance is level.
Adjusting the height of the plinth
If there is a space between the floor and the
bottom of the appliance, you can lower the
plinth to cover it.
Adhesive steam protection foil
Fit the steam protection on the front part of
the worktop along the entire width.
Fixing to the adjacent units
Warning! Use the supplied brackets to
attach the appliance under the worktop
or to the adjacent units, to prevent injury
or damage.
All manuals and user guides at all-guides.com
1. Fit the supplied angular brackets in the
slots on the top of the appliance.
2. Use the supplied screws to secure the
appliance in position (upwards or side-
ways). Make sure the screws are tight-
ened.
Custom made kick-panel
For integrated appliances and full-stainless-
steel door appliances.
We recommend that you make a custom
made kick-panel that aligns your kitchen
cabinets.
• A notched continuous panel is necessary
to prevent door swing interference and to
keep kick-panel alignment with adjacent
units.
• Cut a notch in the kick-panel sufficient to
let the door swing freely under the appli-
ance.
• Make a check for interference. Open and
close the door slowly. If the door touches
the kick-panel, trim to prevent interfer-
ence.
westinghouse 17