General product description 55-75°C 8 18 Fig 1. ’Start & Stop’-button – feed-in/feed-out Feed-in zone Curtain 1/1 Wide Pre-wash zone Signal lamp, red* Chemical wash zone 1 Signal lamp, green* Chemical wash zone 2 Emergency stop Dishwashing tank 3 Curtain, 1/1 Final rinsing zone Paddle, Auto start Drying zone...
General instructions Washing capacity If the instructions in this and other documentation for the equipment are not followed, it could endanger safety and void the supplier’s guarantee and liability for the product. • Read the instructions in this document carefully, since WT730 Low feeding High feeding...
DUO rinsing** Warning! Crushing risk! The final rinse operates using ‘DUO rinsing’. The clean, hot water from the booster goes directly to the second of the final rinse’s two rinsing ramps, before being pumped up and then rinsed through the first rinsing ramp. 100 litres of the used rinsing water passes to the dishwashing tank.
Page 6
Before washing During washing (fig.1) (fig. 2A/B) • Ensure that the strainer plates, strainer boxes, rinse • Press button I for ’Low feeding speed’ and the system and curtains are in their respective places in red LED indicating lamp will come on. the machine.
Warnings and alarms PUMP ALARM The dishwasher will give a warning or register an alarm in xx:xx-xx:xx (xx) the event of a function fault or operational stoppage. PUMP or FAN ALARM indicates that one or more FEEDING ALARM WASH PUMPS or VENTILATION fans are not working. XX:XX •...
To pause during washing Set-up mode In the set-up mode, by pressing the INFO button & Press the ’Stop’ (fig.2A/B) or the ’Start & Stop’(1) • the STOP button at the same time for more than5 button for the feed-in/feed-out (fig.1) sections. seconds, the following information can be updated: The feeding and washing processes will stop, but the •...
Adjust Time & Date (fig.2A/B) Internal cleaning • Switch off the machine by pressing the ’OFF’ button • Press the ’ON’ button to start the machine. . (fig.2A/B) Switch off the ’main switch’ (20) (fig.1). • Press the ’INFO’ button and the ’STOP’...
Page 10
Curtains To balance the steam and the temperature in the dishwasher and to prevent water splashing between different wash zones, insert the curtains correctly as shown in fig. 7A-F. The curtains can only be placed in their correct position due to their design. Curtain variations (fig.7A-F) fig.