Installing The Mower - Toro TimeCutter SS 5425 Operator's Manual

3
Figure 64
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to the
ground.
6. For 60-inch decks, remove the 2 deck-lift springs
(Figure 64).
Figure 65
1. Deck-lift spring (2)
7. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground (Figure 66).
2
1
G014635
g014635
3. Deck bracket
g188405
2. Rear lift rod
2 2
1
1. Mower deck
2. Hanger bracket
8. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
9. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.

Installing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod
6. For 60-inch decks, install the 2 deck-lift springs
65).
7. Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter
Note: For 60-inch decks, attach the 2 front support
rods to the mower deck with the 2 clevis pins and 2
hairpin cotters.
8. Install the mower belt onto the engine pulley.
46
2 2
3 3
G005077
Figure 66
3. Rear lift rod
(Figure 66).
(Figure 64).
g005077
ARK
(Figure