Operating The Ignition Switch; Starting And Shutting Off The Engine - Toro TimeCutter SS 5425 Operator's Manual

Operating the Ignition Switch

1. Turn the ignition key to the S
Note: When the engine starts, release the key.
Important: Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, wait 15 seconds between attempts. Failure to
follow these instructions can burn out the starter
motor.
Note: You may need multiple attempts to start the
engine when you start it the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to the S
the engine.
position (Figure
TART
G008947
Figure 19
position to shut off
TOP
Starting and Shutting Off the
Engine
19).
Starting the Engine
Note: A warm or hot engine may not require choking.
Important: Do not engage the starter for more than
5 seconds at a time. Engaging the starter motor for
more than 5 seconds can damage the starter motor. If
the engine fails to start, wait 10 seconds before operating
the engine starter again.
A
C
g008947
E
F
g027581
Shutting Off the Engine
1. Disengage the blades by moving the blade-control
switch to the O
2. Move the throttle lever to the F
3. Turn the ignition key to the O
the key.
22
B
D
G
Figure 20
position (Figure 20).
FF
position.
AST
position and remove
FF
g027581