Operation
EMU28053
Procedure for tilting down
Power trim and tilt models / power tilt models
1.
Push the power tilt / power trim and tilt
switch "
" (up) until the outboard motor
is supported by the tilt rod and the tilt
support lever / tilt support knob becomes
free.
2.
Release the tilt support lever or pull out
the tilt support knob.
3.
Push the power tilt / power trim and tilt
switch "
" (down) to lower the outboard
motor to the desired position.
UP
DN
DN
38
EMU28060
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
EMU28090
Power trim and tilt models / power tilt
models
The outboard motor can be tilted up partially
to allow operation in shallow water.
ZMU01885
EWM00660
WARNING
Place the gear shift in neutral before
G
setting up for shallow water cruising.
Return the outboard motor to its normal
G
position as soon as the boat is back in
deeper water.
ECM00260
CAUTION:
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
ZMU01936
Otherwise severe damage from overheat-
ing can result.
EMU28184
Procedure for power trim and tilt / power
tilt models
1.
Place the gear shift lever in neutral.
DN
ZMU01979