Traxxas E Revo VXL Owner's Manual page 11

Hide thumbs Also See for E Revo VXL:
Table of Contents

Advertisement

NiMH - Abbreviation for nickel-metal hydride. Rechargeable NiMH
batteries offer high current handling and much greater resistance
to the "memory" effect. NiMH batteries generally allow higher
capacity than NiCad batteries. They can last up to 500 charge
cycles. A peak charger designed for NiMH batteries is required for
optimal performance.
Receiver - The radio unit inside your model that receives signals
from the transmitter and relays them to the servos.
Resistance - In an electrical sense, resistance is a measure of how
an object resists or obstructs the flow of current through it.
When flow is constricted, energy is converted to heat and is
lost. Traxxas power systems are optimized to reduce electrical
resistance and the resulting power-robbing heat.
Rotor - The rotor is the main shaft of the brushless motor.
In a brushless motor, the magnets are mounted to the
rotor, and the electromagnetic windings are built into the
motor housing.
Sensored - Sensored refers to a type of brushless motor that
uses an internal sensor in the motor to communicate rotor
position information back to the electronic speed control.
Sensorless - Sensorless refers to a brushless motor that uses
advanced instructions from an electronic speed control to
provide smooth operation. Additional motor sensors and wiring
are not required.
Servo - Small motor unit in your model that operates the
steering mechanism.
Transmitter - The hand-held radio unit that sends throttle and
steering instructions to your model.
Trim - The fine-tuning adjustment of the neutral position of the
servos, made by adjusting the steering trim knob on the face of
the transmitter.
Thermal Shutdown Protection - Temperature sensing electronics
used in the electronic speed control detect overloading and
overheating of the transistor circuitry. If excessive temperature is
detected, the unit automatically shuts down to prevent damage
to the electronics.
TRAXXAS TQ
RADIO & VELINEON POWER SYSTEM
i
2-channel radio system - The TQi radio system, consisting of
the receiver, the transmitter, and the servos. The system uses
two channels: one to operate the throttle and one to operate
the steering.
Voltage - Voltage is a measure of the electrical potential
difference between two points, such as between the positive
battery terminal and ground. Using the analogy of the garden
hose, while current is the quantity of water flow in the hose,
voltage corresponds to the pressure that is forcing the water
through the hose.
IMPORTANT RADIO SYSTEM PRECAUTIONS
• Do not kink the receiver's antenna wire. Kinks in the antenna wire
will reduce range.
• DO NOT CUT any part of the receiver's antenna wire. Cutting the
antenna will reduce range.
• You must extend the antenna wire in the model as far as possible
for maximum range. In doing so, the antenna wire will be extended
outside of the vehicle body. Do not wrap or coil the antenna wire
to keep it from extending out of the body.
• The antenna wire must be installed into the antenna tube to
protect it from getting cut or damaged, which will reduce range.
When installing the antenna wire into the antenna tube, be careful
not to kink the wire by pressing it against the antenna tube cap.
The antenna wire should extend to just below or to within one-half
inch below the cap.
To prevent loss of radio range,
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct
No
No
No
No
1/16 E-REVO VXL • 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

71076-3

Table of Contents