Bosch PROFACTOR GDS18V-770C Operating/Safety Instructions Manual page 12

GCY42 Connectivity Module
installation
To reduce the risk of injury
read the operating instruc-
tions included with Bosch GCY42 connectivity
module. Operating instructions for GCY42 connectivity
module include important information not covered in
this manual.
Only use Button/coin cell 3V
lithium CR2032 battery. Do
not use any other button/coin cells or other forms of
electrical power supply.
Ensure that battery
replacement is carried out
properly. There is a risk of explosion.
Chemical Burn Hazard. Keep
batteries away from children.
This product contains a lithium button/coin cell battery.
If a new or used lithium button/coin cell battery is
swallowed or enters the body, it can cause severe
internal burns and can lead to death in as little as 2
hours. If you think a battery might have been swallowed
or placed inside any part of the body, seek immediate
medical attention.
Always completely secure the
connectivity module
compartment. If the connectivity module compartment
does not close securely, stop using the product, remove
the battery, and keep it away from children.
When discarding batteries,
insulate the '+' and '–'
terminals with insulating tape. When disposed of
improperly, lithium batteries may short, causing them to
become hot, burst or ignite.
Never dispose of the batteries
in a fire or expose to high
heat. The batteries may explode.
If GCY42 connectivity module is not purchased with the
tool, or if the replacement of the module or the battery
becomes necessary, please follow this procedure (See
Fig. 7):
Assembly
- Using a flat screwdriver or a coin, remove the cover
(A) from the side of the handle, by turning it 1/4 turn
counter-clockwise.
- If the tool is already equipped with the connectivity
module, remove the battery (B), but do not remove
the connectivity module (C).
- If the connectivity module is installed for the first
time, remove the plastic placeholder (D) from the
connectivity module compartment, and place the
connectivity module (C) in the compartment observing
correct orientation. Note: Store the placeholder (D)
in a safe place. Reinsert the placeholder again if the
communications module is removed.
- Next place new battery (B) on the top of the
connectivity module with the "+" polarity facing up.
- Place the cover (A) over the battery and turn it ¼-turn
clockwise to lock using a flat screwdriver or a coin.
Fig. 7
12
A
B
C
D