Ethernet Wan; Cellular Wan - ZyXEL Communications NR Series User Manual

Table 22 Network Setting > Broadband > WAN Backup (continued)
LABEL
Check Fail Limit
Cancel
Apply

7.4 Ethernet WAN

Use this screen to have a LAN port act as an Ethernet WAN port. When the switch goes to the right, the
LAN port acts as an Ethernet WAN port. Otherwise, the LAN port remains as a LAN port. Click Apply to
save your changes back to the Zyxel Device.
Click Network Setting > Broadband > Ethernet WAN to display the following screen.
Figure 54 Network Setting > Broadband > Ethernet WAN

7.5 Cellular WAN

Click Network Setting > Broadband > Cellular WAN to display the following screen. Use this screen to
enable data roaming and network monitoring when the Zyxel Device cannot ping a base station.
Note: Roaming charges may apply when Data Roaming is enabled.
Chapter 7 Broadband
DESCRIPTION
Enter the number of times that your Zyxel Device will ping the IP addresses
configured in the Destination for Connection Check field without getting a response
before switching to a WAN backup connection (or a different WAN backup
connection).
Click Cancel to exit this screen without saving.
Click Apply to save your changes.
NR/FWA Indoor Series User's Guide
106