Stopping Engine; Procedure For Stopping Engine (6X6 Switch); Trimming Outboard Motor - Yamaha F400A Owner's Manual

EMU27823

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU42196
Procedure for stopping engine (6X6
switch)
The engine can be turned off either by press-
ing the Start/Stop button or by turning the
main switch to the "
Situations when stopping engine from main
station (dual-station models) or helm (single-
station models)
(1) Turn the main switch to "
press the Start/Stop button until the en-
gine stops completely.
OFF
1
1. Main switch
1
1. Start/Stop button
" (off) position.
" (off) or
ON
START
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off).
(2) If the Start/Stop button was pressed to
stop the engine in step (1), turn the main
switch to "
(3) Remove the key if the boat will be left un-
attended.
Situations when stopping engine from sub
station (dual-station models)
(1) Press the Start/Stop button until the en-
gine stops completely.
1
1. Start/Stop button
(2) Turn the main switch to "
main station.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off) on the main station.
(3) Remove the key if the boat will be left un-
attended.
EMU27865

Trimming outboard motor

EWM00741
Excessive trim for the operating condi-
tions (either trim up or trim down) can cau-
se boat instability and can make steering
Operation
" (off).
" (off) on the
59