Toro Mower Safety - Toro Z-Master Z153 Operator's Manual

Carefully release pressure from components with
stored energy.
Disconnect battery or remove spark plug wire before
making any repairs. Disconnect the negative terminal
first and the positive last. Reconnect positive first and
negative last.
Use care when checking blades. Wrap the blade(s) or
wear gloves, and use caution when servicing them.
Only replace blades. Never straighten or weld them.
Keep hands and feet away from moving parts. If
possible, do not make adjustments with the engine
running.
Charge batteries in an open well ventilated area, away
from spark and flames. Unplug charger before
connecting or disconnecting from battery. Wear
protective clothing and use insulated tools.
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.

Toro Mower Safety

The following list contains safety information
specific to Toro products or other safety information
that you must know that is not included in the ANSI
standards.
This product is capable of amputating hands and feet and
throwing objects. Always follow all safety instructions to
avoid serious injury or death.
This product is designed for cutting and recycling grass or,
when equipped with a grass bagger, for catching cut grass.
Any use for purposes other than these could prove
dangerous to user and bystanders.
General Operation
Allow only responsible adults who are familiar with
the instructions to operate the machine.
Be sure the area is clear of other people before
mowing. Stop the machine if anyone enters the area.
Do not mow in reverse unless absolutely necessary.
Always look down and behind before and while
backing.
Be aware of the mower discharge direction and do not
point it at anyone. Do not operate the mower without
either the entire grass catcher or the guard in place.
Slow down before turning. Sharp turns on any terrain
may cause loss of control.
Turn off blades when not mowing.
Keep hands, feet, hair and loose clothing away from
attachment discharge area, underside of mower and
any moving parts while engine is running.
Stop the engine before removing the grass catcher or
unclogging the chute.
Mow only in daylight or good artificial light.
Watch for traffic when operating near or crossing
roadways.
Do not touch equipment or attachment parts which
may be hot from operation. Allow to cool before
attempting to maintain, adjust or service.
Before operating a machine with ROPS (roll over
protection) be certain the seat belts are attached to
prevent the seat from pivoting forward.
Use only Toro-approved attachments. Warranty may
be voided if used with unapproved attachments.
Slope Operation
Slopes and ramps are a major factor related to
loss-of-control and tip-over accidents, which can result in
severe injury or death. All slopes and ramps require extra
caution. If you cannot back up the slope or if you feel
uneasy on it, do not mow it.
DO
If a steep slope must be ascended, back up the hill, and
drive forward down the hill, keeping the machine in
gear.
Remove obstacles such as rocks, tree limbs, etc. from
the mowing area. Watch for holes, ruts or bumps, as
uneven terrain could overturn the machine. Tall grass
can hide obstacles.
Use slow speed so that you will not have to stop while
on the slope.
Follow the manufacturer's recommendations for wheel
weights or counterweights to improve stability.
Use extra care with grass catchers or other
attachments. These can change the stability of the
machine.
Keep all movement on slopes slow and gradual. Do
not make sudden changes in speed or direction.
Avoid starting or stopping on a slope. If tires lose
traction, disengage the blades and proceed slowly
straight down the slope.
When operating machine on slopes, banks or near drop
offs, always have ROPS (roll over protection)
installed.
When operating a machine with ROPS (roll over
protection) always use seat belt.
5