Cleaning And Storage - Toro Z-Master Z153 Operator's Manual

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, engine, hydraulic pumps and motors.
3. Service the air cleaner; refer to Air Cleaner, page 28.
4. Grease and oil the machine; refer to Greasing and
Lubrication, page 32.
5. Change the crankcase oil and filter; refer to Engine
Oil, page 29.
6. Change the hydraulic filter; refer to Hydraulic System,
page 16.
7. Check the tire pressure; refer to Tire Pressure, page 35.
8. Charge the battery; refer to Battery, page 41.
9. Check the condition of the blades; refer to Cutting
Blades, page 26.
10. Prepare the machine for storage when non–use occurs
over 30 days. Prepare machine for storage as follows.
11. Add a petroleum based stabilizer/conditioner to fuel in
the tank. Follow mixing instructions from stabilizer
manufacture. (1 oz. per gallon or 7.8ml per liter). Do
not use an alcohol based stabilizer (ethanol or
methanol).
Note: A fuel stabilizer/conditioner is most effective when
mixed with fresh gasoline and used at all times.
A. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the fuel tank;
refer to Fuel Tank, page 31.
C. Restart engine and run it until it stops.
D. Choke or prime the engine. Start and run engine
until it will not start. Operate primer, if equipped
on machine, several times to ensure no fuel
remains in primer system.
E. Dispose of fuel properly. Recycle as per local
codes.
Important
Do not store stabilizer/conditioned gasoline
over 90 days.
F. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
G. Stop engine, allow to cool and drain the fuel tank;
refer to Fuel Tank, page 31.
H. Restart engine and run until it stops. Repeat, on
"CHOKE" until engine will not restart.
I. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned gasoline over 90
days.
12. Remove the spark plug(s) and check its condition;
refer to Spark Plug, page 30. With the spark plug(s)
removed from the engine, pour two tablespoons of
engine oil into the spark plug hole. Now use the starter
to crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
13. Clean any dirt and chaff from the top of the mower.
14. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with a
garden hose.
15. Check the condition of the drive and deck belts.
16. Check and tighten all bolts, nuts and screws. Repair or
replace any part that is damaged or defective.
17. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
18. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it in a memorable place. Cover the machine to
protect it and keep it clean.
45