Hydraulic System - Toro Z-Master Z153 Operator's Manual

Figure 44
Where to Add Light Oil or Spray
Lubrication
Lubricate the machine in the following areas with spray
type lubricant or light oil. Lubricate every 160 hours.
Seat switch actuator.
Brake handle pivot.
Brake rod bushings.
Motion control bronze bushings.

Hydraulic System

Checking the Hydraulic Fluid
Check the hydraulic fluid level:
Before engine is first started.
After first 8 operating hours.
After 25 operating hours.
Fluid Type: Mobil 1 15W-50 synthetic motor oil.
Important
Use only oil specified. Other fluids could
cause system damage.
System Capacity: 2.1 qt. (2.0 l)
1. Position machine on a level surface, stop the engine
and set the parking brake.
2. Clean area around filler neck of hydraulic tank
(Fig. 45).
3. Remove cap from filler neck. Look inside to check if
there is fluid in the reservoir (Fig. 45).
4. If there is no fluid, add fluid to reservoir
approximately a 1/4 (6mm) below the top of baffle.
5. Run the machine 15 minutes to allow any air to purge
out of the system and warm fluid.
6. Recheck level while fluid is warm. Add fluid to raise
level to top of the baffle, if required.
Note: Fluid level should be to the top of the baffle when
fluid is warm (Fig. 45).
7. Install cap on filler neck.
1
m–4159
3
1. Cap
2. Baffle
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
If hydraulic fluid is injected into the skin it
must be surgically removed within a few hours
by a doctor familiar with this type of injury.
Gangrene may result if this is not done.
Keep body and hands away from pin hole leaks
or nozzles that eject high pressure hydraulic
fluid.
Use cardboard or paper to find hydraulic leaks.
Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
Make sure all hydraulic fluid hoses and lines
are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to hydraulic system.
33
2
Figure 45
3. Fluid level—full
Warning
m–4280