Recycling The Clippings - Toro Super Recycler 20383 Operator's Manual

2. Set all 4 wheels to the 83 mm (3-1/4 inch) cut
setting.
3. Take a half sheet of newspaper and crumple it
into a ball small enough to go under the machine
housing (about 76 mm or 3 inches in diameter).
4. Place the newspaper ball about 13 cm (5 inches)
in front of the machine.
5. Start the engine.
6. Engage the blade.
7. Release the blade-control bar.
8. Immediately push the machine over the
newspaper ball.
9. Shut off the engine and wait for all moving parts
to stop.
10. Go to the front of the machine and check the
newspaper ball.
Note:
If the newspaper ball did not go under
the machine, repeat steps
11. If the newspaper is unravelled or shredded, the
blade did not stop properly, which could result
in an unsafe operating condition. Contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it; refer to
Removing the Grass Bag (page 16)
the clippings. If the side-discharge chute is on the
machine, remove it and lock the side-discharge door;
refer to Removing the Side-Discharge Chute (page
18) before recycling the clippings.
Important:
Ensure that the rear-discharge plug
is locked in place. To lock the plug: Raise the
discharge door (Figure
in until it snaps into place behind the tabs, and
rotate the lever on the plug to the left
4 through 10.
before recycling
24), firmly push the plug
(Figure
1. Discharge door
25).
1. Lever
Note:
To unlock the plug, rotate the lever on the plug
to the right (Figure
15
Figure 24
2. Rear-discharge plug
Figure 25
2. Tabs
25).
g017463
g010084