Yamaha GRIZZLY YFM70GPAN Owner's Manual page 38

EWB00132
WARNING
Always stop the ATV before changing from
four-wheel drive to four-wheel-drive differen-
tial gear lock or vice versa.
The ATV handles differently in four-wheel drive
than in differential gear lock in some circum-
stances. Changing from four-wheel drive to
differential gear lock or vice versa while mov-
ing may cause the ATV to handle differently un-
5
expectedly. This could distract the operator
and increase the risk of losing control and
causing an accident.
1
1. On-Command drive switch "4WD/LOCK"
2. Drive switch lock lever
2
LOCK
4WD
To access the "4WD/LOCK" switch, set the
"2WD/4WD" switch to "4WD", and then move the
drive switch lock lever to the right.
TIP
 When the switch is set to "LOCK" or "4WD", the
differential gear lock icon and indicator light will
flash until the differential gear is completely
locked or unlocked.
 When the icon and indicator light are flashing,
turning the handlebar back and forth will help
the differential gear lock to engage or disen-
gage.
 Riding before the differential gear is properly en-
gaged or disengaged (e.g., when the icon and
indicator light are flashing) will cause the vehicle
speed to be limited until the differential gear is
completely engaged or disengaged.
 When the ATV is in four-wheel-drive differential
gear lock, the maximum traveling speed is limit-
ed to 35 km/h (22 mi/h). However, if conditions
require full engine power to be available, push
and hold the override switch to disable the dif-
ferential gear lock speed limiter. (See page
5-12.)
5-14