Configure The Detector - Honeywell BW Ultra User Manual

3. Now inert mode is activated. and default inert mode low alarm set point is 5% vol and high
alarm set point is 5% vol.
4. To come back to normal mode, when the O
20 sec, a message will pop up on LCD to activate normal mode, user has to press and hold for 3
secs.
5. Then normal mode is activated.

Configure the Detector

You can configure the Honeywell BW Ultra detector's device and sensor using Safety Suite
Device Configurator (SSDC). Necessary to configure detector settings:
Honeywell BW Ultra detector
l
IR Link adapter or IntelliDoX® docking station
l
Computer with Safety Suite Device Configurator (SSDC) software installed.
l
For device settings, a startup message can be added; Confidence Compliance Beep can be
activated, bump tests can be forced, stealth mode can be enabled, etc.
For sensor settings, the calibration gas type and frequency can be changed, the bump test
interval and alarm setpoints can be set, STEL and TWA can be selected, etc.
You can perform some other settings changes with Safety Suite Device Configurator (SSDC).
Latching Alarms
l
IntelliFlash Mode
l
IntelliFlash Interval (seconds)
l
Confidence/Compliance Beep
l
Confidence/Compliance Beep Interval (seconds)
l
Datalog Interval (seconds)
l
Language
l
Hole Watch Mode
l
Disable Button Power Off
l
Time Zone/Time Settings. (Time Zone and UTC offset in minutes)
l
LEL over span (as it is used by both whittle LEL & IR LEL)
l
STEL / TWA back up
l
Clear Peaks Type
l
BLE enable
l
Normal display
l
Pairing Code
l
BW Ultra
concentration becomes > 18 %vol for more than
2
29 User Manual