Installing The Front Bezel And End Caps; Setting The Unit Id Using The Odp Button - Bosch DSX-N1D8X4-12AT Installaton Manual

DSA E-Series (E2800 12-bay)
6.
7.
Notice!
i
Install the expansion units below and above the controller unit, keeping the weight in the
lower portion of the cabinet.
4.2

Installing the front bezel and end caps

A front bezel covers the front of the controller unit and the expansion unit, while left and right
end caps cover the mounting flanges on each unit.
To install the front bezel:
1.
2.
To install the end caps:
1.
2.
3.
4.3

Setting the unit ID using the ODP button

You can set or change the unit ID for a controller unit or a expansion unit by using the
operator display panel (ODP) button.
Before you begin
You might need to remove the front bezel or the end cap to see the ODP button.
Bosch Security Systems B.V.
Secure the unit to the back of the rails by inserting two M5 screws through the brackets
at the unit and the rail kit bracket.
If applicable, replace the end caps or the system bezel.
Note: Additional documentation can be found on the Bosch online catalog.
Position the front bezel in front of the controller unit or the expansion unit so that the
holes at each end align with the fasteners on the unit.
Snap the bezel into place.
Position the left end cap in front of the controller unit or the expansion unit so that the
holes in the end cap align with the fasteners on the left side of the unit.
Snap the end cap into place.
Repeat these steps for the right end cap.
Installaton manual
Installation | en 21
2021.05 | V3 | DOC