BMW F800GT Rider's Manual page 112

9
110
Install screws 1 and tighten to
the specified tightening torque.
Brake caliper to fork leg
z
30 Nm
Insert the wheel-speed sensor
into the bore and install
screw 1.
Remove the adhesive tape
from the wheel rim.
Operate the brake several
times until the brake pads are
bedded.
Removing rear wheel
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxili-
ary stand; BMW Motorrad re-
commends the BMW Motorrad
rear-wheel stand.
Install the rear-wheel stand
( 96).
OE
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Engage first gear.
Remove studs 1 from the rear
wheel, while supporting the
wheel.
Roll the rear wheel out toward
the rear.