BMW F800GT Rider's Manual page 109

an adhesive label indicating the
position of the RDC sensor.
Removing front wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw 1 and remove
the wheel-speed sensor from
its bore.
ATTENTION
Unwanted inward movement
of the brake pads
Component damage on attempt
to install the brake caliper or be-
cause brake pads have to be
forced apart
Do not operate the brakes with
a brake caliper not correctly
secured.
Remove screws 1 of the brake
calipers on left and right.
Force the brake pads 1 slightly
apart by rotational movement
of the brake caliper 2 against
brake disc 3.
Mask off the parts of the wheel
rim that could be scratched in
the process of removing the
brake calipers.
Carefully pull the brake calipers
back and out until clear of the
brake discs.
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
9
107
z