Operation; Emergency Stopping; Start The Engine - Ariens Razor 911373 Operator's Manual

Models 911375, 911379
See Figure 19.
1. Push OPC lever forward and raise or
lower handlebar to desired position.
2. Release OPC lever and move handlebar
up or down slightly until it locks in desired
position. Ensure handlebar is locked in
position before operating.
Figure 19
• For storage, rotate handlebar completely
forward. See Figure 20.
Figure 20

OPERATION

CAUTION: AVOID INJURY. Read
and understand the Safety section
before proceeding.
IMPORTANT: All references to left, right, front
or rear are given from the perspective of
operator in operator's position, facing the
direction of forward travel.

EMERGENCY STOPPING

1. Release the operator presence control
(OPC) lever.
2. Models 911375, 911379:
Release the wheel drive control lever.
3. Wait for moving parts to stop before
leaving operator's position.

START THE ENGINE

Electric Start
Model 911379
NOTICE: DO NOT start engine when charger
is connected to battery.
1. Pull operator presence control (OPC)
lever against handlebar and hold position.
2. Turn engine key to start position and
release when engine starts.
NOTICE: DO NOT operate starter
continuously for more than 15 seconds or
damage may occur.
IMPORTANT: If engine does not crank,
battery may be discharged. Start unit with the
recoil starter handle. See Manual Start on
page 16.
EN - 15