Kenwood TK-5220 K Service Manual page 50

TK-5220
Item
Panel tuning mode
10. MSK 1) Adj item: [An MSK]
Deviation Adjust: [✳✳✳✳]
adjust *4 Deviation meter
LPF: 15kHz
[Narrow] HPF: OFF
PTT: ON
Press [ ] key to store
the adjustment value.
[Wide] 1) Adj item: [Aw MSK]
Adjust: [✳✳✳✳]
PTT: ON
Press [ ] key to store
the adjustment value.
*4: Refer to the "Necessary Deviation adjustment item for each signaling and mode" table on page 51.
11. VOX1 1) Adj item: [VOX1]
adjust Adjust: [✳✳✳]
AG: 1kHz/45mV at
MIC terminal
12. VOX10 1) Adj item: [VOX10]
adjust Adjust: [✳✳✳]
AG: 1kHz/3mV at
MIC terminal
13. BATT 1) Adj item: [BATT]
detection Adjust: [✳✳✳]
writing PTT: ON
14. BATT [Panel test mode]
detection 1) CH-Sig: 1-1
check BATT terminal
voltage: 6.0V while
transmitting
50
ADJUSTMENT
Condition
PC test mode
equipment
1) Adj item: [MSK Devia- Deviation
tion (Analog Narrow)] meter
Deviation meter Oscilloscope
LPF: 15kHz
HPF: OFF
PTT: Press
[Transmit] button.
Press [Apply]
button to store the
adjustment value.
1) Adj item: [MSK Devi-
ation (Analog Wide)]
PTT: Press
[Transmit] button.
Press [Apply]
button to store the
adjustment value.
1) Adj item: [VOX1] AG
AG: 1kHz/45mV at
MIC terminal
1) Adj item: [VOX10]
AG: 1kHz/3mV at
MIC terminal
1) Adj item:[Battery Power
Warning Level] meter
PTT: Press DVM
[Transmit] button.
1) Test Channel
Channel: 1
Test Signaling
Mode: Analog
Signaling: 1
BATT terminal
voltage: 6.0V while
transmitting
Measurement
Test-
Unit Terminal Unit
Panel ANT Panel
Panel Universal
connector
Panel ANT
BATT
terminal
Adjustment
Specifi cations /
Parts Method
[Panel Write the value as 1.50kHz±0.05kHz
tuning followings.
mode] 513 (Reference
[ ], value)
[ ]
[PC test
mode]
[ ],[ ]
3.00kHz±0.05kHz
[Panel tuning mode]
After apply signal
from AG, press [ ]
key to store the
adjustment value.
[PC test mode]
After apply signal
from AG, press
[Apply] button to
store the adjust-
ment value.
Press the PTT
switch or [Transmit]
button on the PC
window.
Apply 6.20V to bat-
tery terminal.
Confi rm that one
pre-determined nu-
meric in the range 1
to 256 appears.
[Panel tuning mode]
Press [ ] key to
store the adjust-
ment value.
[PC test mode]
Press [Apply] but-
ton to store the
adjustment value.
Check The transceiver
can transmit with
causing the LED to
blink.
Remarks