Steps
1. Align the screw holes on the stand hinges with the screw holes on the display-assembly base.
2. Replace the 10 screws (M3x4.5) that secure the stand hinges to the display-assembly base.
Next steps
1. Install the
I/O
cover.
2. Install the
back
cover.
3. Install the stand.
4. Follow the procedure in
System-board shield
Removing the system-board shield
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
53