Bissell BigGreen Commercial BG697 plus User Manual page 4

Operation
Turn on the switch (item 10.01) and push the sweeping machine in front of you at normal
walking speed (the brushes will point in the opposite direction) and lift the sliding handle
slightly. Bumps with a height of 2-3 cm can be easily driven over by lightly pushing down on the
sliding handle. After termination of the brushing process, turn off the switch (item 10.01) of the
machine and recharge the battery.
The machine must be turned off as soon as the brushes start to spin slowly
or the LED turn red –in order to prevent a total discharge and damage of
the battery.
If the sweeper will be turned off by the electronics within a short time, the
load at the motors is too high. Then check the brushes plates for free movement and no
blockings, as jammed stones, coiled threads and so on. Remove all blockings before
opeation the sweeper.
LED display
In battery mode the battery charge status will be displayedat the LEDs next to the main switch of
the sweeper.
Green LED:
Red LED lights up:
Red and green LED blinking: The sweeper was due to low battery charge and switched off by
The machine can also be operated without its motor. In this case, simply push the machine
without turning on the motor.
Overload protection
The motor is provided with an overload protection in order to prevent damage to the machine. In
the case of an overload (jammed brooms) the machine turns off automatically. If this should
occur, the first step is to remove the blockage in the brooms (e.g. due to spooled cords etc.).
Thereafter, operation can be continued by restarting the motor.
Emptying the waste container
The waste container must be emptied at regular intervals in order to ensure efficient sweeping
results. To open the waste container, pull the container handle (item 6.05) upward. After
removing and emptying the waste container, replace it and lock it in by pushing down on the
container handle.
Storage
The Bissell BG697 plus sweeping machine can be best stored vertically. In this position, the
brushes are protected against damage and the wear will be reduced.
Charging the battery
The battery will be charged with the serial socket battery charger. Attention: charging is only to
be carried out in a dry, well ventilated room with turned off machine. In order to charge the
machine, insert the cable into the charging socket of the sweeping machine (item 10.02) and the
line cord into a 110 - 230V outlet. After termination of the charging process, the power supply
unit must be separated from the mains and the machine. The complete charging process takes
approx. 7-8 hours. Always store the machine with charged battery in order to prevent a total
version 03/2015
Normal sweeping mode, the battery charge is sufficient.
The battery charge is low. Stop and charge the battery with the
charger.
the built-in electronics. Switch sweeper off and recharge the
battery. After charging the normal operation is possible.
Start with Serialnumber :11/2015100395 -4-