Switching Input Signal - BenQ LW600ST User Manual

Entering the password recall procedure
1. Press and hold OK for 3 seconds. The projector will
display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to provide
proof of purchase documentation to verify that you
are an authorized user of the projector.
Changing the password
1. Go to Advanced Menu - Settings > Security Settings > Change Password.
2. Press OK. The message "Input Password" appears.
3. Enter the old password.
• If the password is correct, another message "Input New Password" appears.
• If the password is incorrect, the password error message will appear, and the message
"Input Password" appears for your retry. You can press BACK to cancel the change or try
another password.
4. Enter a new password.
5. Confirm the new password by re-entering the new password.
Disabling the password function
To disable password protection, go to Advanced Menu - Settings > Security Settings > Power
On Lock and press / to select Off. The message "Input Password" appears. Enter the
current password.
• If the password is correct, the OSD menu returns to the Security Settings page. Press /
to select Off. You will not have to enter the password next time turning on the projector.
• If the password is incorrect, the password error message will appear, and the message
"Input Password" appears for your retry. You can press BACK to cancel the change or try
another password.
Though the password function is disabled, you need to keep the old password in hand should you ever need
to re-activate the password function by entering the old password.

Switching input signal

The projector can be connected to multiple devices at the same
time. However, it can only display one full screen at a time.
When starting up, the projector automatically searches for the
available signals.
Be sure the Advanced Menu - Settings > Auto Source Search
menu is On if you want the projector to automatically search for
the signals.
To select the source:
1. Press SOURCE. A source selection bar appears.
2. Press / until your desired signal is selected and press OK.
To allow the projector to automatically search for the Wi-Fi display source, go to Advanced Menu - Settings
> Auto Source Search and select HDMI+Wi-Fi.
24 Operation
Recall Password
Please write down the recall code, and contact
BenQ Customer Center.
Recall Code:
Return