Table of Contents
Advertisement
3.1. Inserting batteries
Battery type: R03/LR03/AAA x 2
1
2
9
5
1
Pull the cover in the direction of the arrow and open it
until it is trapped.
2
Remove the cover.
1 Turn the remote controller over and push the back
side of the cover and remove the claws by curving
the cover.
2 Pull in the direction of the arrow while curving the
cover.
3
Put batteries as shown in the fi gure above.
4
Press this button as shown in the fi gure above.
Use the tip of a ballpoint pen or other small objects.
5
Press
to start the setting for day of the week and
the clock.
6
Press
(
to Sunday).
Press
to continue.
7
8
Press
(
Press the buttons to change the clock by a minute.
Press and hold the buttons to change the clock by 10 minutes.
* By pressing
from a 12-hour to a 24-hour clock.
9
Press
to complete the setting.
Be close to the indoor unit. If you press the button from a
distance, settings may not be properly sent.
10
Install and close the cover.
NOTES:
• Use the specifi ed type of batteries only.
• Do not mix diff erent types or new and used batteries together.
• Batteries can be used for about 1 year in ordinary use.
• If the remote control range noticeably shortens, replace the
batteries and press
3.2. Indoor unit
Air fi lter
*1)
Intake grille
Air cleaning fi lter
Vertical louvers
Indicator lamps
En-3
3
7
RESET
6
8
4
to set the day of the week (Monday
)
to set the clock.
)
, the time indicator can be changed
as shown in the fi gure above.
For Manual Auto operation and Filter
indicator reset (Refer to page 14.)
Front panel
Rating label
Drain hose
Remote control
signal receiver
*2)
*1) Before starting the operation, make sure that the intake grille is
closed completely. Incomplete closing may aff ect the proper function
or performance of the product.
*2) Indicator lamps light in the following conditions. It cannot see when
the indicator lamp is off .
Color
Name
Operation
Green
Timer
Orange
Economy
Green
WLAN
Orange
3.3. Remote controller
When you use the optional remote controller, the appearance
and the operation procedure may diff er.
For details, refer to the operation manual of each remote controller.
: The setting must be done while the setting screen is displayed
for each function.
: The button is controllable only when the air conditioner is operating.
: The instruction is relating to the WLAN control.
Signal transmitter
Aim at the signal receiver of the indoor unit properly.
• Operating range is approximately 7 m.
• [
] will appear when the signal is transmitted.
• The indoor unit will emit a beep when it receive the signal
properly. If there is no beep, press the button again.
Remote controller display
In this section, all the possible indicators are displayed for description.
In actual operation, the display is linked with the button operation, and
only shows the necessary indicators for each setting.
For Basic operations ..................... Refer to page 5.
Starts or stops the air conditioner operation.
Changes the operation mode.
Adjusts the setting temperature.
For 10°C Heat operation ............... Refer to page 7.
Activates the 10°C Heat operation.
For Energy saving operation ........ Refer to page 7.
Activates or deactivates the Economy
operation.
For Outdoor Unit Low Noise operation
Activates or deactivates the Outdoor Unit Low
Noise operation.
Do not press this button in normal use.
It starts the test run (for use by authorized service personnel only).
NOTE: I f the test run starts unintentionally, press
run.
Operation or condition
Normal operation
Timer operation
Economy operation
10°C Heat operation
WLAN control is active.
... Refer to page 7.
to quit the test
Advertisement
Table of Contents
