Table of Contents
Advertisement
6.2 Descale
To set descale function, press
dicator light blinks and the
and hold the
(B6) button for 3 seconds to start descaling
(see instructions in section Descaling) .
If you accidentally activate descaling, you can stop it by pressing
and holding the
(B6) button for at least 10 seconds.
6.3 Auto-off
To set the Auto-off time press
5 minutes (default)
1.5 hour
3 hour
If the machine is in Auto-off mode, press any button on the con-
trol panel to turn on the appliance.
6.4 Default values
To reset the default values press
cator light blinks. Press and hold the
seconds to resets all menu settings.
All settings will be restore to factory.
6.5 Water hardness
To set the one of the 3 levels of water hardness, press
button:
Water Hardness
Corresponding
Test Result
indicator light
n
nn
nnn
nnnn (default)
6.6 Measuring water hardness
The
(B3) indicator light comes on following a predetermined
period of operation that depends on a water hardness setting.
The machine can also be programmed according to the actual
hardness of the local water supply, in which case descaling may
be required less frequently.
•
Remove the water hardness test indicator paper (A17)
from its pack.
•
Immerse the paper completely in a glass of water for one
second.
•
Remove the paper from the water and shake lightly. After
about a minute, 1, 2, 3, or 4 red squares form, depending
on the hardness of the water.
(B6) button; the (B3) in-
indicator light turns on. Press
(B7) button:
(B5) button; the indi-
(B5) button for 3
(B4)
Level
1
soft water
2
medium water
3
hard or very hard water
7. CLEANING
Important: Before maintenance or cleaning of the appliance,
turn it off, unplug from the main socket and allow to cool.
Do not use solvents, abrasive detergents or alcohol to clean the
coffee machine.
Do not use metal objects to remove encrustations or coffee de-
posits as they could scratch metal or plastic surfaces.
The drip tray and small cup tray, are dishwasher safe.
If the machine is not used for more than one week, before using
it again, we strongly recommend you perform a rinse cycle.
The following parts of the machine must be cleaned and dry
regularly:
drip tray (A8): the drip tray should be emptied and
•
cleaned after each use or when the level indicator (red)
rises through the metal grid.
Remove the drip tray, empty the water and clean the drip
tray with a cloth, dry and then reassemble the drip tray un-
til you hear a 'click' .
•
cups filter (A15), (A16): After using the appliance, always
rinse the filters under abundant running water. Use the
brush (A9) to clean (fig. 13).
coffee spout (A7): After every 200 coffees, rinse the cof-
•
fee spout by delivering about 0.5 l of water from the coffee
spout (press the
coffee).
•
water tank (A2): Clean the water tank regularly (about
once a week) and whenever you replace the water softener
filter (if present) with a damp cloth and a little mild wash-
ing up liquid, especially internally in the sensor area (fig. 12);
rinse with running water.
•
steam wand (A5): After every use, remove with a soft
damp cloth any milk residues from the steam wand. Turn
the steam dial (A4). The appliance delivers water from the
steam wand.
Wait that the steam wand cool down and open the hole of
the nozzle with the cleaning needle (A10) (fig. 13).
7
(B6) button without using ground
12
Hide quick links:
Advertisement
Table of Contents
