Table of Contents
Advertisement
16
INSTALLATION MENU
StandBy
- Set the sending and receiving scenario of OpStandBy(0x0c) command.
- Ths detailed scenario is described on the table below.
Send
Send Only
Receive Only
All
Off
Forced Initialize
- This setting will be enabled When CEC mode is set as 'TVLink-CEC'
- If 'Enable" is selected, TV will change its input source to HDMI1 by any HDMI-CEC simulation from
a device.
HTNG Public Display Mode
- If you use following functions via TVLink-HCEC, HTNG Hotel mode will be set as "Yes"
automatically. (*Power On Default, Start Volume, Maximum Volume, Minimum Volume, or Start
Volume)
- Even if 'Public Display Settings Operation' is set as No, above settings are still effective.
Clock Setup
Clock Source
- You can select 'Off' , 'TV' , 'NTP' , 'Admin' by pressing
- NTP : Clock is synchronized using Network
network cable is connected.
- Admin : It's automatically set to Admin when clock is updated by commercial protocols like
TVLink-HCEC, TVLink-Interactive, or HCAP API.
- Off : Clock is synchronized using any available clock source.
- TV : Clock is synchronized using particular TV program.
Receive
O
X
X
O
O
O
X
X
button.
Time Protocol. It's only enabled when
Advertisement
Table of Contents
