Planar GX2MP User Manual page 18

Power cord
8 | GX2MP Display
Connect the Video Cable and Power Cord
Turn your computer off. Leave the power cord plugged into
the grounded outlet. Use the video cable and cord shipped with
the display.
To connect the display and board
1 Plug one end of the DVI cable into the video port and the power
cord into the input port on the interface plate. (See the illustration
(left) below.) Secure the connections.
2 Plug the other end of the video cable into the video port on
the installed display controller. (Connect the first display of a
two-headed system, or a single display to the primary (DVI #1) port.
See illustration (right) below.) Secure the connection.
3 Plug the power cord into a grounded AC outlet.
4 Repeat steps 1 to 3 to connect a second display to the controller.
5 Power on the display first, then the computer.
DVI cable Port assignment with DVI cable connection