Planar Dome C2 Reference Manual page 9

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Configure Display Settings
Configure Windowing
DPMS Screen Saver
Console Modification
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
Video Modes
Connector Ports
LED Status Lights
USB Connection
To set up the display properly
•
Allow the display to warm up to room temperature before turning it on.
•
Avoid sudden temperature changes. Sudden changes may cause condensation that
can damage the display.
•
Turn off your computer, but leave it plugged into a grounded outlet.
•
Secure the display properly onto a standard VESA 100-mm mounting unit if you elect not
to use the desk stand.
•
Do not step on or place anything on top of the power cord.
•
Do not set up the display near strong light sources.
•
Do not block the vents on the back of the display or install the display in a built-in
enclosure. Blocked vents cause excessive heat to build up inside the display, increasing
risk of fire.
•
Do not expose the display to water or excessive moisture.
•
Do not place the display near a heat source.
•
Do not hang anything from the display.
•
Use the display only in an indoor setting.
To disconnect the power supply properly
First, turn off your computer and other connected devices. Then unplug the power
supply from the display or wall outlet.
Dome CX Display System for Solaris
Reasons to disconnect power
•
Power cord is damaged.
•
Liquid spills inside the
display case.
•
Display is dropped or case
is damaged.
•
Display needs service or repair.
•
Display or case needs cleaning.
x